Small Knife Project - sentimental about wood
One of those small projects that comes along. A small knife with a plastic handle. Could easily have been tossed in the bin. The tang was very short which contributed to the demise of the handle. The only reason I bothered resurrecting the small knife was because it has a nice practical scabbard. I didn’t make a video as it was too stop start. I only managed a few photos. The first problem was how to secure the blade in a new handle. I came up with the idea of drilling two holes in the blade and pinning it through the handle. The blade was too hard to drill. I heated the tang to soften it and drilled two 4mm holes to accept the brass rod. Following this I hardened and tempered the tang. The handle was fashioned from Silver Birch and made in two halves wiht a small recess routed out to house the blade. The blade is so thin that I only created a housing in on side of the handle. The two parts were glued together with 5 minute two part epoxy. I modeled the handle for the small knife on the original plastic handle. After a bit bandsaw work and trip to the belt sander the handle took shape. I finished up with a bit of hand sanding and then uses a food safe oil from Ubeaut to protect the handle. About an hour of actual working time. So the plastic goes in the bin and the blade lives on.
Post to Tumblr