Plastic Chair in Wood by Maarten Baas (2008)
I'm obsessed with this chair. The artist takes a flimsy hunk of injection-molded plastic that's been cost-cut to hell and back, and insists that we look at it with fresh eyes and understand its beauty. And they went about it in the most labor-intensive way I can think of.
Absolutely nothing about this design is convenient to execute in wood. Every piece is curved, most have compound curves. This is artisan craftsmanship: it's inherently slow, manual, and skilled. Notice, also, that most features of this chair must be thicker and heavier than on the plastic chairs being imitated. Injection-molded chairs can be produced in this shape in a matter of minutes with far less material at very low cost.
If these flowing, organic curves are so beautiful in polished wood, perhaps they are also beautiful in the mass-produced chairs that are far more accessible. Perhaps we should remember to admire designs that succeed enough to become ubiquitous. I don't know about you, but I'll never see injection-molded chairs the same way again.







